Cisco 10000 - Manual (Page 193)

5-29
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 5 Configuring the Layer 2 Tunnel Protocol Access Concentrator and Network Server
L2TP Network Server
Required Configuration Tasks for LNS
To configure the Cisco 10000 series router as an LNS, perform the following required configuration
tasks:
• Configuring the Virtual Template Interface, page 5-29
• Configuring the LNS to Initiate and Receive L2TP Traffic, page 5-29
Note You must also configure the LAC and RADIUS server to communicate with the LNS. For more
information, see the
“Required Configuration Tasks for LAC” section on page 5-7 or see your RADIUS
documentation.
Configuring the Virtual Template Interface
To configure a virtual template interface, enter the following commands:
Configuring the LNS to Initiate and Receive L2TP Traffic
To configure the Cisco 10000 router, acting as the LNS, to initiate and receive L2TP traffic, enter the
following commands:
Command Purpose
Step 1 Router> enable Enters privileged EXEC mode.
Step 2 Router# config terminal Enters global configuration mode.
Step 3 Router(config)# interface virtual-template
number
Creates a virtual template interface and enters interface
configuration mode.
Step 4 Router(config-if)# ip vrf forwarding <name> Maps the virtual template interface to a VRF routing table.
Step 5 Router(config-if)# ip unnumbered loopback
<number>
Enables IP without assigning a specific IP address on the
LAN.
Step 6 Router(config-if)# ppp authentication {pap |
chap | ms-chap}
Enables PAP or CHAP authentication on the virtual
template interface, which is applied to VAIs.
Command Purpose
Step 1 Router> enable Enters privileged EXEC mode.
Step 2 Router# config terminal Enters global configuration mode.
Step 3 Router(config)# vpdn enable Enables VPDN networking on the router and informs the
router to look for tunnel definitions in a local database
and on a remote authorization server (home gateway) if
one is present.
Step 4 Router(config)# vpdn-group group-name Defines a local group name for which you can assign other
VPDN variables. Enters VPDN group configuration mode.
Step 5 Router(config-vpdn)# accept-dialin Configures the LNS to accept tunneled PPP connections
from the LAC and creates an accept-dialin VPDN
subgroup.