Cisco 10000 - Manual (Page 288)

10-18
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 10 Configuring Address Pools
Overlapping IP Address Pools
Verifying Local Pool Groups for IP Overlapping Address Pools
To verify that you have successfully configured a pool group, enter the following commands in
privileged EXEC mode and check the resulting output for the pool group name:
Configuration Examples for Overlapping IP Address Pools
This section provides the following configuration examples:
• Generic IP Overlapping Address Pools Example, page 10-18
• IP Overlapping Address Pools for VPNs and VRFs Example, page 10-19
Generic IP Overlapping Address Pools Example
The following example shows the configuration of two pool groups and includes pools in the base system
group. In this example:
• Pool group grp1 consists of pools p1_g1, p2_g1, and p3_g1.
• Pool group grp2 consists of pools p1_g2 and p2_g2.
• Pools lp1 and lp2 are members of the base system group.
• The IP address 10.1.1.1 overlaps grp1, grp2, and the base system group.
• No overlapping addresses occur within any group including the unnamed base system group, which
consists of pools lp1 and lp2.
ip local pool p1_g1 10.1.1.1 10.1.1.50 group grp1
ip local pool p2_g1 10.1.1.100 10.1.1.110 group grp1
ip local pool p1_g2 10.1.1.1 10.1.1.40 group grp2
ip local pool lp1 10.1.1.1 10.1.1.10
ip local pool p3_g1 10.1.2.1 10.1.2.30 group grp1
ip local pool p2_g2 10.1.1.50 10.1.1.70 group grp2
ip local pool lp2 10.1.2.1 10.1.2.10
Note The preceding example shows pool names that provide an easy way to associate a pool name with a
group (when the pool name stands alone). This association is an operational convenience. There is no
required relationship between the names used to define a pool and the name of the group.
Command Purpose
Router# show ip local pool [pool-name [group
group-name]]
Displays statistics for defined IP address pools.
Router# show ip local pool Displays statistics for all pools configured.
Router# show ip local pool pool-name Displays statistics for a specific pool you specify.
Router# show ip local pool group Displays statistics for all pools in a base system group.
Router# show ip local pool group group-name Displays all pools in a specified group.