L2vpn local switching-hdlc/ppp, Prerequisites of l2vpn local switching-hdlc/ppp, Restrictions of l2vpn local switching-hdlc/ppp – Cisco 10000 User Manual

Page 378: Ppp like-to-like local switching, L2vpn local switching—hdlc/ppp, Prerequisites of l2vpn local switching—hdlc/ppp, Restrictions of l2vpn local switching—hdlc/ppp

Advertising
background image

18-10

Cisco 10000 Series Router Software Configuration Guide

OL-2226-23

Chapter 18 Configuring L2 Virtual Private Networks

L2VPN Local Switching—HDLC/PPP

L2VPN Local Switching—HDLC/PPP

The L2VPN Local Switching - HDLC/PPP feature enables service providers to support different
encapsulations over HDLC local switched circuits that function as back-to-back circuits. The
provisioned HDLC Local Switched circuits can also be backed by using PWRED.

Prerequisites of L2VPN Local Switching—HDLC/PPP

In Cisco IOS Release 12.2(33)SB, the L2VPN Local Switching - HDLC/PPP, you must ensure that
interfaces must be HDLC encapsulated on the PE router. The CE routers can choose any HDLC-based
encapsulation, including Frame Relay and PPP.

Restrictions of L2VPN Local Switching—HDLC/PPP

In Cisco IOS Release 12.2(33)SB, the L2VPN Local Switching - HDLC/PPP feature has the following
restrictions:

On the PE HDLC interface, the IP address cannot be configured because it conflicts with the
connect command.

Interworking is not supported on HDLC/PPP interfaces.

Only same-speed interfaces should be connected, to avoid arbitrary packet drops due to a higher
speed interface overrunning a lower speed one.

For some HDLC/PPP applications which are sensitive to time delay, the PE may introduce some
network delay, enough to prevent the HDLC/PPP link from coming up because of a protocol timeout
(an ISDN Q921 link).

PPP Like-to-Like Local Switching

Some applications, such as transport of compressed voice between the two CEs, require a setup of an
end-to-end PPP session between two CE routers that are connected to the same PE router. In such cases,
HDLC pass-through mechanism is proposed and the interworking scenario is simplified to PPP transport
for like-to-like services. PPP local switching functionality on the PE router provides simple HDLC
connectivity between two end-users found on different CE routers as shown in

Figure 18-1

.

Figure 18-1

PPP Local Switching

The interfaces are HDLC encapsulated on the PE router. The CE routers may use PPP-based
encapsulation.

RFC 1661 (Protocol)

Data

FCS


PE

PPP
CE

PPP
CE

Advertising