Cisco 10000 - Manual (Page 460)

19-42
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 19 Configuring Multilink Point-to-Point Protocol Connections
Related Documentation
• Unsequenced—The serial link is unsequenced and packets can arrive in a different order than the
peer transmitted them. To compensate for this, multilink relaxes its lost fragment detection
mechanisms.
• Receive only (or receive only pending)—The link is in idle mode or is about to be put in idle mode.
Processing of arriving data on the link continues normally, but data is not transmitted on the link.
The remote system is expected to not send data on the link.
Verification Example for the show interfaces multilink stat Command
Example 19-12 shows sample output for the show interfaces multilink stat command. In the example,
the number of packets in and out display for each of the specified switching paths.
Example 19-12 Sample Output for the show interfaces multilink stat Command
Router# show interfaces multilink 8 stat
Multilink 8
Switching pathPkts InChars InPkts OutChars Out
Processor3666531774
Route cache000 0
Total36 665 31 774
Related Documentation
This section provides hyperlinks to additional Cisco documentation for the features discussed in this
chapter. To display the documentation, click the document title or a section of the document highlighted
in blue. When appropriate, paths to applicable sections are listed below the documentation title.
Feature Documentation
Multilink PPP Cisco IOS Dial Services Configuration Guide: Terminal Services,
Release 12.1
Part 4: PPP Configuration > Configuring Media-Independent
PPP and multilink PPP
MLP over ATM RFC 1990, The PPP Multilink Protocol
Designing and Deploying Multilink PPP over Frame Relay and
ATM Tech Note
MLP over Serial RFC 1990, The PPP Multilink Protocol