Canon BJC-50 - Manual (Page 64)

62
Chapter 6
Maintaining the Printer
This chapter covers the care and maintenance of your Canon BJC-50 printer including instructions for
transporting, storing, and cleaning the printer, replacing BJ Cartridges, and cleaning the print head.
Your printer requires little maintenance but to keep it in top operating condition, you should perform
the following routine maintenance.
Recharging and replacing the battery pack
This section shows you how to recharge and replace your battery pack.
Install and use only a Canon Li-Ion Battery LB-50 in this printer. You must install the battery pack
and leave it installed in the printer even if you intend to use the printer only with the AC adapter. If
the battery pack is not installed, the printer CHARGE/ERROR lamp will light orange and the printer
will beep six times.
Recharging the battery pack
When the power in the battery pack runs low, the CHARGE/ERROR lamp flashes orange and
the printer beeps four times. When the power in the battery pack is depleted, the
CHARGE/ERROR lamp lights orange and the printer beeps twice (one long and one short
beep).
Follow this procedure to recharge the battery pack.
NEVER ATTEMPT TO RECHARGE THE BATTERY PACK WITH ANYTHING OTHER THAN
THE UNIVERSAL
AC ADAPTER AD-360U SUPPLIED.
For best results, charge the battery pack at room temperature 10°C to 30°C (50°F to 86°F). The
battery pack will recharge very slowly at low temperature and will not charge fully at high
temperature.
62