RearviewSafety RVS-MDVR - Manual (Page 16)

W 2 0 1 2 P
Figure 3-21
G-SENSOR SETUP
SENSOR SETUP
Figure 3-20
3.5 VEHICLE INFORMATION
It includes SENSOR, SPEED, SETUP. G-SENSOR
1.When users install MDVRs, define the sensors according to different port settings, see the
figures 3-20. Like change name "INPUT" to "Front door", "Brakes", and etc.
2."ENABLE" on means switching on the sensor, user can select alarm mode as the recording mode,
and then select record and alarm on/off on this menu. Actually, sensor input is also alarm input, with
high/low level effective. Users normally use above 5V high level to form the loop.
3.5-1 SENSOR SETUP- ALARM INPUT
Figure 3-19
3.5-2 G-SENSOR SETUP
Before setup acceleration, users must clear X/Y/Z parameters. Acceleration can be analysed as
a three-dimensional XYZ coordinate axis, which can express three status: up-down ,right-left ,
front-back. Uniform speed will not affect on it. Acceleration setup mainly setup thresholds that are
defined via testing. Please see Chapter 4.3 for more detailed information.
Figure 3-18
14
SD Card Mobile DVR User Manual
14