W 2 0 1 2 p, 19 sd card mobile dvr user manual 19, 3 ptz setup – RearviewSafety RVS-MDVR User Manual

Page 21

Advertising
background image

W 2 0 1 2 P

3.7-2

WIFI SETUP

INSTRUCTIONS:

Insert WIFI antenna into the backside mount of the demo , Edith the following information at the
interface as pictures (Figure 3-36)
1.Make enable and Encrypt status ON authentication mode including WPA , WPA-PSK,OPEN
and share. Encryption contains TKIP and AES, authentication mode is not effective currently ,so
only choose the OPEN state ( Open-certifications is not required .then WIFI can communicate
properly ,Select WEP encryption ,refer Figure 3-36 , Press ENTER key to set above information
and different options switching.
2.Enter the SSID and password (wireless network and password ), IP ,MASK and gateway , all the
set must be match with your local wireless network , SSID /PASSWORD ,press ENTER to set up,
IP,netmask and gateway press CANCEL and the number keys to set up .
3.Check system information, refer Figure 3-35, if the WIFI signal is over -60db, it indicates WIFI
signal is excellent .4.If want connect into CMS server ,refer the center of the IP field in Figure 3-10,
enter the CMS center IP and port numbe.r

"

"

"

"

"

"

"

Figure 3-36

ENCRYPT TYPE:WEP

WIFI SETUP

WIFI SETUP

ENABLE

ENCRYPT

AUTH MODE

ENCRYPT TYPE

SSID

PASSWORD

ON

IP ADDR

NETMASK

GATEWAY

OPEN

WEP

192.168.001.012

255.255.255.000

192.168.001.001

ON

SAVE

3.7-3

PTZ SETUP

INSTRUCTIONS :

1.Protocol:PELCO-D and PELCO-P optional.

2.Baudrate:There are 1200/2400/4800/9600 four options, user can modify different bits rates

according to different PTZ .

3.D-bits:Normally is 8, now here is defaulted to select 1-8.

4. S-bit:Normally is 1 , no need modify when has been defaulted.

5.Verify:Decide to select which checking way.

6. Address num:Enter address mum and must be as the same as the PTZ s address code,

Normally PTZs address code is default at 1 ,PTZ address code is adjustable and need set

different address code to indentify different PTZ.

7. Cable connecting: PTZ anode connect RS485-A and Negative connect RS485-B. .

'

'

" "

Figure 3-37

PTZ SETUP

PTZ SETUP

Protocol Baudrate Dbit Sbit Verify Num

CH1

PELCO-D

2400 8 1 None 1

CH2

PELCO-D

9600 8 1 Even 12

Ch3

PELCO-D

9600 8 1 Even 12

CH4

PELCO-D

9600 8 1 Even 12

SAVE

19

SD Card Mobile DVR User Manual

19

Advertising