RearviewSafety RVS-MDVR - Manual (Page 5)

W 2 0 1 2 P
1.3: MDVR NOTICE:
To make sure MDVR safety use, acquire satisfactory performance, and extend the service life
of the equipments , please fully consider the following factors when install the equipment :
1.
When install and operate the equipment , please obey all the electronic products guide, vehicles
and other connection equipments requirements
2.Power supply and equipment grounded : D
irect input range of the machine power supply is from
DC 8V-36V , please don t get inverse,and.input can t be short circuit.Please note the power supply
capacity of the power line. Even the equipment is shut down , it may be charged . please avoid short
circuit . Before connect with other external devices, please cut the connection between this
equipment and the power supply. The input mode of equipment sensor is level mode , with external
voltage below 4V is considered as low level , above 4V and below 30V is considered as high level.
Beyond 30V will damage the equipment. Correctly connect the earth wires of the device and the
vehicle and form a loop; If don t use the machine for a long time . It s better to cut the power supply
completely to extend the service life
3.Humidity requirements :
Install equipment in dry environment, avoid damp, water-drop, water
spray and other places. Don't take the equipment installed in places where water will sag or wet
places liquid will drip down ; Do not use wet hand to touch the equipment,Do not stand in the water
or touch with other water places while contact the equipment, it may get electric shock
4.Installation position:
To extend the life of the equipment, please try to install it in place with weak vibration, such as
behind the driver's seat .The equipment should be installed on the vehicle's ventilation installation
part .Equipment installed on the plane should remain a distance of 6 inches (15 centimeters)
away from other objects to assure the air flow and heat dissipation ; Don't install it on the enclosed
area, such as car trunk. This machine can be right side installed or side loading. The equipment s
external wiring must have the enough intervals and external flame retardant protection , to ensure
the wire not to be bent or leakage of electricity due to wear and vibration; Ensure that equipment
away from heat source of the vehicle, the equipment can't have sundry pile up around, prohibit
placing anything on the equipment .
5.Equipment safety:
Ensure passengers or the driver can't intervene and damage the equipment unit, camera, wire and
other accessories . Don't install the equipment near other components of vehicle ; When install
equipment components, camera, accessories and wire, launch vehicles may cause damage to the
equipment, Keep the vehicles static during the installation process ,to prevent equipment falling
from vehicles.
'
'
' '
'
Installation notes:
1.Equipment contains the electronic devices, please handle gently during transport .
2.All installation and maintenance must be executed by the professional qualified person.
3.This product cant be installed in part of the vehicle where there was erosion by rain or other
liquid for a long time .
4.Installation and all materials must be able to withstand the weight of the fuselage.
5.Keep fuselage away from the heat source, dust and strong magnetic fields.
6.Do not put heavy objects on the equipments.
7.Don't flush the equipment directly while clean the Vehicles .
8.The equipment output power shall not connect to devices that are not recommended.
9.Don't insert finger or some objects from the gap while operate the equipments.
10.Without professional guide, please do not open or unload the equipment.
11.Don't change any modules when the mainframe is charged.
'
3
SD Card Mobile DVR User Manual
3