Sound Anchors BAREFOOT STUDIO MONITOR STAND - Manual (Page 2)

PARTS LIST
For each stand
1. 1 ea. Barefoot base weldment.
2. 1 ea. 56” Upright
3. 1 ea. Speaker mounting plate.
4. 1 ea. Speaker mounting tube.
5. 2 ea. Speaker mounting bars.
6. 2 ea. 7/16-14 x 3 socket head cap screws.
7. 2 ea. 7/16 spherical washers.
8. 2 ea. 7/16-14 x 3/4 socket head cap screws.
9. 4 ea. 3/8-16 hardened spikes
10. 5 ea. 3/8-16 jam nuts
11. 4 ea. 3/8 flat washers
12. 4 ea. M8 x 35 socket head cap screw
13. 4 ea. 5/16-18 x 1 1/2 socket head cap screw
14. 4 ea. 5/16 flat washers
15. 1 ea. 3/8 hex key
16. 1 ea. 6mm hex key.
17. 2 ea. Leveling Pad
18. 2ea. 7/16-14 x 1” flathead socket head cap screws.
19. 2ea. 5/16-14 x 1 1/4 ” flathead socket head cap screws.
1. Install one spike, washer and jam nut combination into each insert on the bottom of
the stand so that about 1/2” of thread is left protruding from the stand. Finger tighten
only (use no tools) you will tighten them when you level the stands with the spikes later.