Sound Anchors BAREFOOT STUDIO MONITOR STAND User Manual
Page 9
HEIGHT ADJUSTMENT
The procedure is the same for both horizontal and vertical setups.
1. Loosen the lower of the two mounting bolts.
2. Slide the slide the speaker and mount into the desired height position.
3. Tighten the lower bolt to it’s original tightness.
4. Your height is now rough set you may want to fine tune it again once you get your
stands located in their final position.
LEVELING SYSTEM
1. Before you level your stands you must position them where you will be using them. We
recommend that you check level each time you move your speakers even if only an
inch.
2. Leveling the stands is accomplished by threading the spikes in or out. You will want all
4 spikes exerting the same amount of force on the floor.
3. The reference for level is the upright not the base. You will need to position a carpen-
ters level vertically on the side surface of the upright to adjust side to side level.
4. Repeat this procedure on the rear surface of the upright to adjust front to back level.
5. You may want repeat this procedure a few times if you want to get your level perfect.
6. Check that all 4 spikes are exerting the same amount of force on the floor and tighten
the jam nuts on the spikes.
Loosen
This Bolt