Sound Anchors BAREFOOT STUDIO MONITOR STAND - Manual (Page 4)

3. You have three options for assembling the speaker mounting plate.
Left plate image shows no 7/16-14 x3/4 screws this image is used for either horizontal or
vertical speaker set-ups where no speaker tilt will be required.
Center plate image shows which holes the 7/16-14 x3/4 screws are inserted into for hori-
zontal speaker set-ups where speaker tilt will be required.
Right plate image shows which holes the 7/16-14 x3/4 screws are inserted into is used for
vertical speaker set-ups where speaker tilt will be required.
If you are going to require either horizontal or vertical tilt the 7/16-14 x3/4 screws must be
tightened so that the ends of the screws protrude through the plate equally about 1/4” as
shown in the far right image (side view).
4. Fasten speaker mounting tube to speaker mounting plate using (2 ea.) 5/16-18 x 1 1/4”
Long Flat Head Socket Cap Screws. Note that the tube is countersunk on one surface, this
surface is the top surface.