Sound Anchors BAREFOOT STUDIO MONITOR STAND User Manual
Page 7
Securing the MM27 to the stand Vertical.
CAUTION: Some MM27s came with M8 mounting inserts. Sound Anchors supplies both
5/16-18 and M8 bolts Test fit to see which inserts your speaker has by inserting a 5/16 bolt
with onlyyour fingers (no tools). If the 5/16 bolt does not thread in easily try an M8 bolt.
If there is not less than 1/2” between the bolt head and the back of the speaker you will
need shorter screws. Shorter screws can be purchased from a good hardware store or you
can contact Sound Anchors. In any case if the bolts do not gthread in easily without tools
do not force them. Your speakers may be damaged.
HORIZONTAL SET-UP
1. Remove the handles from the speaker. It is actually only necessary to remove the han-
dles from one side but we like the looks better when both handles removed
2. Place your speaker on the mount assembly so that the inserts that were previously
used to fasten handles to the speaker line up with the holes in the speaker mount.
3. See the above caution.
4. Fasten the speaker to the stand using 4 ea. of the appropriate 5/16-18 or M8 bolts with
flat washers. Finger tighten only.
5. Tighten the flathead screws that fasten the mounting bars to the mounting tubes.
6. Tighten the speaker mounting screws. Do not over tighten them as this could damage
the speaker.
7. Adjust the leveling pad so that it just touches the speaker then tighten 1/4-1/2 turn by
hand an lock down the jam nut.