Sony CCD-TR9 - Manual (Page 19)

u a /-
• .'f-^'rpL
.•,;,!a?s'i;
i/i^
.liiiâi ' Iffi¿Slfeí ' : '&Ú Ét-^r'^'Í - ' '
Using the Remote Commander
With the Remote Commander, you can record yourself with your friends or family,
or conveniently control the playback of your tape from a distance.
Note
To prevent
misoperation
Battery leakage
Notes
1
Set REMOTE COMMANDER ON/OFF on
the camcorder (bottom) to ON. on ^9S off
■ REMOTE
COMMANDER
Set POWER on the camcorder as follows:
(a) When recording, 1) While pressing the small
green button on POWER, slide POWER to
CAMERA, 2) turn STANDBY up.
(b) When playing back. While pressing the small
green button on POWER, slide POWER to VTR.
POWER
ICM<ERAtj>f^rVTn
POWER
Remote sensor
Point the Remote Commander to the remote
sensor on the camcorder and press the
appropriate button on the Remote
Commander.
(Maximum distance and angle for remote controi)
The buttons that have the same name on the Remote Commander and on the
camcorder functions equally.
When you slide HOLD in the direction of the arrow,
none the buttons on the Remote Commander will
work to prevent any misoperation if you accidentally
press a button.
Hold switch
To avoid damage from possible battery leakage, remove the batteries when you
do not plan to use the Remote Commander for a long time.
• Be sure that the Remote sensor is not in sunlight or strong light. In that case,
you may not be able to operate with the Remote Commander.
• This camcorder works by the signals of VTR2 commander mode. If you use
another Sony VCR at commander mode VTR2, we recommend you to change
the commander mode or cover the remote sensor of the VCR with black paper
to avoid misoperation.
• Be sure that there are no obstructions between the Remote Commander and
the camcorder.
• Be sure to insert the lithium battery with the correct polarity. Otherwise, you
cannot operate with the Remote Commander.
Chapter 2: Basic Operation
19