Sony CCD-TR9 - Manual (Page 23)

Chapter 3: Advanced Operation
Alternative Power Sources
This section shows your avaiiable choice of the following power sources for your
camcorder: battery pack (see page 7), house current (on this page), and 12/24 V
car battery (see page 24). Choose the appropriate power source depending on
where you want to use your camcorder.
Place Power source Accessory to be used
Outdoors Battery pack
Battery pack NP-55 (supplied),
NP-77HD, NP-77H, NP-77, NP-66H,
NP-55H
Indoors House current
AC power adaptor AC-V35/V35A
(supplied), AC-S10, AC-V55, AC-V30
In the car
12 V or 24 V car
battery
DC pack DCP-77
Note on power Disconnecting the power source or removing the battery pack during recording or
sources playback may damage the inserted tape. If this should happen, supply power
again immediateiy.
Using House Current
Use the supplied AC-V35/V35A AC power adaptor.
1 Connect the AC power adaptor to a wall outlet.
2 Lift up the viewfinder.
3 Align the right side of the connecting piate with the line on the camcorder,
and slide it to the right.
4 Set CHARGE/VTR to VTR.
To remove the
connecting (Hate
See the instruction manual of the AC power adaptor If you need additional
information about the AC power adaptor.
Proceed in the same way as the battery pack. See page 7.
Chapter 3: Advanced Operation
23