Sony CCD-TR9 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting a Wired Remote Control Unit
When you connect an optional wired remote control unit or editing controller to
the C REMOTE control jack on the camcorder, you can operate your camcorder
from a distance. In this case, be sure to set the REMOTE COMMANDER ON/OFF
switch of the camcorder (bottom) to OFF.
C REMOTE control jack
About
e
(LANG)
C stands for Local Application Control Bus System. The C control jack is used
for controlling the tape transport of video equipment and peripherals connected
to it. ITiis jack has the same function as the connectors indicated as CONTROL
L or REMOTE
Preventing Accidental Erasure
Slide the tab on the cassette to expose the red mark. This will prevent accidental
recording.
If you try to record with the red mark exposed, the IS and
±
indications flash
inside the viewfinder and in the display window, and you cannot record. To re
record on this tape, slide the tab back out covering the red mark.
Notes on handling
Never insert anything in the small holes on the rear of the cassette. These
holes are used to sense the type and thickness of the tape, or whether the red
mark is exposed or covered, etc. Store cassettes in their cases and keep them
in an upright position to prevent intrusion of dust and uneven winding.
Store cassettes in their cases and keep them away from heat, humidity, direct
sunlight, magnetic fields, dust and mold.
Chapter 3: Advanced Operation
31