Sony CCD-TR9 - Manual (Page 8)

il2^.
Inserting the Lithium Battery
To active the clock in memory, you need to insert a lithium battery. Make sure
you use the supplied lithium batteries.
1
Pull out the lithium battery holder from the
bottom of the camcorder.
Insert the supplied CR2025 lithium battery with
the + (plus) side facing up.
Put the lithium battery holder back into the
camcorder.
Lithium battery life The battery lasts for approximately 1 year in normal operation. When the lithium
battery becomes weak, the time or date indication keeps flashing in the display
window and inside the viewfinder for about 5 seconds when POWER is set to
CAMERA. In this case, replace the battery with a Sony CR2025 or Ouracell
DL-2025 lithium battery. Use of any other battery may present a risk of fire or
explosion.
Inside the viewfinder
O' 1
-n.
n 1 MN
In the display window
While replacing the lithium battery, keep the battery pack or other power source
attached. Otherwise, you will need to readjust the date and time.
To change the Remove the lithium battery holder from the camcorder, and pull out the lithium
lithium battery battery and insert a new one.
WARNING Battery may explode if mistreated. Do not recharge, disassemble, or dispose of in
fire.
Cautions • Keep the lithium battery out of the reach of children.
Should the battery be swallowed, consult a doctor immediately.
• Wipe the battery with a dry cloth to assure good contact.
• Be sure to install the battery with the correct polarity.
3 Chapter 1: Getting Started