Sony GDM-2038 - Manual (Page 5)

Precautions
Ifislallitlon
Prevent internal heat build-up by allowing adequate air circulation. Do not place the
unit on surfaces (rugs, blankets, etc.) nor near materials (curtains, draperies) that
may block the ventilation holes.
Do not install the unit near heat sources such as radiators or air ducts, nor in a
place subject to direct sunlight, excessive dust, mechanical vibration or shock.
Do not place the unit near equipment which generates magnetism, such as a
converter or high voltage power lines.
Warning on Power Connection
Maintenance
The supplied power cord may be connected only to 100 to 120 V AC, 50/60 Hz
power sources. Do not use it for 220 to 240 V AC, 50/60 Hz power sources.
To disconnect the power cord, wait for at least 30 seconds after turning off the
power for discharging the static electricity on the CRT display surface.
After the power has been turned on, the CRT is demagnetized for approximately 5
seconds. This generates a strong magnetic field around the bezel which may affect
the data stored on magnetic tape or disks near the bezel. Place such magnetic
recording equipment and tapes/disks apart from this unit.
Clean the cabinet, panel and controls with a soft cloth lightly moistened with a mild
detergent solution. Do not use any type of abrasive pad, scouring powder or
solvent, such as alcohol or benzine.
The surface of the CRT display is AR-coated. Never use a strong solvent, such as
benzine, to clean the surface, otherwise the AR-coating will come off.