Sony GDM-2038 - Manual (Page 7)

[3 COLOR SELECT switch 0
Switches the color temperature to L (Low), M (Middle),
or H (High).
Each color temperature is preset as follows:
L: approximately 5000°K
M: approximately 6500°K
H: approximately 9300°K
[ 2 ] Color adjustment button 0
Press to adjust the color temperature. The color
adjustment indicator [ 3 ] lights, showing the color
temperature is adjustable.
[ 3 ] Color adjustment indicator 0
The indicator lights when the color adjustment button [ 2 ]
is pressed. While the indicator is lit, select the color
element out of R (Red), G (Green), and B (Blue) by
using the SELECT <3/0 buttons
Adjust the selected element by using the ADJUST +/-
buttons (red) [31-
Press the color adjustment button [ 2 ] again to turn the
indicator off.
[ 4 ] Indicators 0
One of the indicators that corresponds to the adjustment
item selected by the SELECT <3/0 buttons [|] lights.
While the indicator is lit, adjust the item by using the
ADJUST +!- buttons (blue) [U or (red) [ t ]-
[I] SELECT <3/0 buttons 0 0
Press to select the adjustment item so that the indicator
corresponding to the selected item lights.
[6] ADJUST +!- buttons (blue) 0
Adjust the item shown below the indicator selected by
using the SELECT buttons <3/0 [5].
[ 7 ] ADJUST -f/- buttons (red) 0 0
Adjust the item shown above the indicator selected by
using the SELECT buttons <3/0 [U.
[H Power switch and lamp
Press the I side of the switch to turn on the power.
Press the O side to turn it off.
VIDEO OUT (video output) connectors (BNC)
Use these connectors to distribute the video signal fed to
this unit to another monitor.
When cables are connected to these connectors, the
75-ohms termination of the VIDEO IN connectors [3] is
released automatically.
VIDEO IN (video input) connectors (BNC)
Accept RGB video signals (0.714 Vp-p, positive).
When no external sync signal is applied, an internal sync
signal (0.286 Vp-p, negative) must be added to the G
(green) signal.
The optimum display may not be obtained when using
computer or video board of high output level
(approx. 1.0 Vp-p). In such a case, adjust the display by
lowering the contrast, or use computer or video board of
adequate output level.
[ 13 ] SYNC OUT (sync output) connectors (BNC)
Use these connectors to distribute the external sync
signal fed to this unit to another monitror.
When cables are connected to these connectors, the
termination of the SYNC IN connectors [iil is released
automatically.
Use a coaxial cable that is less than 3 meters long and of
75 ohms impedance to connect the VIDEO OUT and
SYNC OUT connectors. If the cable is too long, or if its
impedance is incorrect, or if several monitors are
connected in cascade, the picture may be noisy with
horizontal and vertical lines.
When not distributing signals to another monitor,
disconnect the cables from the VIDEO OUT and SYNC
OUT connectors.
If the BNC connector of the signal distributing cable is not
adequate, the termination impedance may not be
disconnected properly. Always use the cable with
adequate BNC connectors.
Swivel/Tilt stand
The stand allows the angle of the screen to be adjusted
by 90 degrees horizontally and by 15 degrees vertically.
AC IN connector
7