Chauvet INTIMIDATOR 200 - Manual (Page 12)

Page 12 of 22 Intimidator™ Scan LED 200 User Manual (Rev. 02a)
Standalone Operation
Master/Slave Mode (Sound-Active, Auto Mode)
This mode allows a single unit, the master, to operate in one of the standalone
modes, while one or more fixtures, slaves, synchronize their responses to the master.
Master:
The master fixture may be set in any of the STANDALONE modes: sound-active,
fast, or slow.
Slave:
1) Press <MODE/ESC> until one of the standalone modes appears on the LED
screen (SLAu, nStS, nAFA, nASL).
2) Using <UP> and <DOWN>, select SLAu.
3) Press <ENTER>.
Only connect 32 fixtures to a single DMX daisy chain!
Automatic-Slow
This fixture has a preprogrammed chase that will operate in a preprogrammed, slow
playback speed.
Access this mode via the control panel on the front of the fixture. Please see the
instructions below for further explanation.
1) Press <MODE/ESC> until one of the standalone modes appears on the LED
screen (SLAu, nStS, nAFA, nASL).
2) Using <UP> and <DOWN>, select nASL.
3) Press <ENTER>.
Automatic-Fast
This fixture has a preprogrammed chase that will operate in a preprogrammed, fast
playback speed.
Access this mode via the control panel on the front of the fixture. Please see the
instructions below for further explanation.
1) Press <MODE/ESC> until one of the standalone modes appears on the LED
screen (SLAu, nStS, nAFA, nASL).
2) Using <UP> and <DOWN>, select nAFA.
3) Press <ENTER>.
Sound-Active
This fixture has a preprogrammed, sound triggered chase.
Access this via the control panel on the front of the fixture. Adjust the microphone
sensitivity from the control panel. Please see the chart below for further explanation.
1) Press <MODE/ESC> until one of the standalone modes appears on the LED
screen (SLAu, nStS, nAFA, nASL).
2) Using <UP> and <DOWN>, select nStS.
3) Press <ENTER>.
The fixture will only respond to the low frequencies of the music (bass and
drums).