Chauvet INTIMIDATOR 200 - Manual (Page 4)

Page 4 of 22 Intimidator™ Scan LED 200 User Manual (Rev. 02a)
Product at a Glance
Use on Dimmer x Auto Programs P
Outdoor Use x Auto-ranging Power Supply P
Sound Activated P Replaceable Fuse P
DMX P User Serviceable x
Master/Slave P Duty Cycle x
Safety Notes
Please read the following notes carefully because they include important safety
information about the installation, usage, and maintenance of this product.
· Keep this User Manual for future consultation. If you sell this product to another
user, be sure that they also receive this document.
· Always make sure that the voltage of the outlet to which you are connecting this
product is within the range stated on the decal or rear panel of the fixture.
· This product is for indoor use only! To prevent risk of fire or shock, do not expose
this fixture to rain or moisture.
· Make sure there are no flammable materials close to the unit while operating.
· Always install this product in a location with adequate ventilation, at least 20 in (50
cm) from adjacent surfaces.
· Be sure that no ventilation slots on the unit’s housing are blocked.
· Always disconnect this product from the power source before cleaning it or
replacing the fuse.
· Make sure to replace the fuse with another of the same type and rating.
· If mounting this product overhead, always secure it to a fastening device using a
safety cable.
· The maximum ambient temperature (Ta) is 104° F (40° C). Do not operate this
product at higher temperatures.
· In the event of a serious operating problem, stop using the unit immediately.
· Never try to repair this product. Repairs carried out by unskilled people can lead
to damage or malfunction. Please contact the nearest authorized technical
assistance center.
· Never connect this product to a dimmer pack.
· Make sure the power cord is not crimped or damaged.
· Never disconnect the power cord by pulling or tugging on the cord.
· Never carry a fixture from the power cord or any moving part. Always use the
mounting bracket or the handles.
· Always avoid direct eye exposure to the light source when this fixture is on.