Chauvet INTIMIDATOR 200 - Manual (Page 9)

Intimidator™ Scan LED 200 User Manual (Rev. 02a) Page 9 of 22
Mounting
Orientation
The Intimidator™ Scan LED 200 may be mounted in any position, provided there is
adequate room for ventilation around it.
Rigging
Before deciding on a location for this product, always make sure that it will be easy to
access the unit for maintenance and programming purposes.
Make sure that the structure or surface onto which you are mounting this product can
support its weight. Please see the Technical Specifications section of this manual for
weight information.
When mounting this product overhead, always use a safety cable. Mount the fixture
securely to a rigging point, whether an elevated platform or a truss.
When rigging this product onto a truss, you should use a mounting clamp of
appropriate weight capacity. The bracket has a 13 mm hole, which is appropriate for
this purpose.
When power linking multiple fixtures, you must always consider the length of the
power linking cable and mount the fixtures close enough for the cable to reach them.
The bracket knobs allow for directional adjustment when aiming the fixture to the
desired angle. Loosen or tighten the bracket knobs using only your bare hands. Using
tools could damage the knobs.
The double bracket yoke/mounting brackets also serve as floor supports or surface
mounting. When mounting this fixture on the floor, make sure that the fixture and its
cables are away from people and vehicles.
Mounting Diagram
Bracket
Bracket
Adjustment Knob