Setting up the remote commander, Inserting the batteries, Using the remote commander – Sony SLV-M10HF User Manual
Page 5: Set /ivideol to, Step 2 setting up the remote commander
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
step 2
Setting up the remote commander
Inserting the batteries
Insert two size AA (R6) batteries by
matching the + and - on the batteries
to the diagram inside the battery
compartment.
Insert the negative (-) end first, then
push in and down until the positive (+)
end clicks into position.
Using the remote commander
You can use this remote
commander to operate this VCR
and a Sony TV or AV receiver.
Buttons on the remote
commander marked with a dot
(•) can be used to operate your
Sony TV.
The RECEIVER VOL + /- and
MUTING buttons can be used to
operate your Sony AV receiver.
Remote sensor
æ D
jSiP
-W-u
■ 1_________ 1°
[TV|/VIDEO
RECEIVER
VOL +/-
MUTING
To operate
the VCR
a Sony TV
Set /IVIDEOl to
I VIDEOl and point at the remote sensor on the VCR
and point at the remote sensor on the TV
* •
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use-the remote commander for an extended period of timft-remo\ e
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery with an old one.
• Do not use different types of batteries.
• Some Sony AV receivers may not be operated with the remote commander.
continued
Getting Started