Sony SLV-M10HF - Manual (Page 50)

Setting up VCR Plus* (continued)
• POWER
О
Press POWER to turn off the VCR.
The VCR sets the program guide channels from 0:00 am to 5:00 am
while the VCR is turned off. (It takes about 1 hour to complete
channel mapping.)
Channel map
Station ID number
To select the channel map
If the program information signal in your area
has several channel map patterns (up to 8), the
Choose your Cable CH MAP menu appears:
• the first time you turn on the VCR after
completing channel mapping
• after selecting AUTO and pressing the cursor
stick (OK) on the SMART CHANNEL
MAPPING menu
In this case, you have to select the channel map
on the Choose your Cable CH MAP menu.
Find the VCR Plus+ Channel Line-up Chart in your program guide.
For details, see page 48.
Push the cursor stick to to select the channel map number you
MAP ll 2 3 4 5 6 7 8|
-I kabc }125{ CNN 98
KCBS
KAET
WNET
Use |»»| lo
Then
push
Push
4 MTV 55
4 ------
5 ------
select
M
to quit
Channel number
1
2
3
want by checking the channel number in the program guide.
Press the cursor stick (OK).
Notes
• It takes about 1 hour to complete channel mapping.
• The VCR can receive the program information signal only while the VCR is turned
off and no timer recordings are set.
• The VCR cannot set the guide channels correctly unless you enter the ZIP/POSTAL
CODE in your area.
• When you move to a different area, you must set up the VCR again and enter your
new ZIP/POSTAL CODE in the EASY SET UP procedure.
50 Getting Started