Samsung 430 - Manual (Page 28)

Advanced Features
Switching between Anynet+ Devices
Anynet+ devices connected to the TV are listed.
If you cannot find a device you want, press the Red button to refresh the list.
Select a device, and then press the ENTER Q button. You can switch to the selected device.
The Device List menu appears only when you set Anynet+ (HDMI-CEC) to On in the System menu.
• Switching to the selected device may take up to 2 minutes. You cannot cancel the operation during the switching
operation.
• If you have selected an external input mode by pressing the SOURCE button, you cannot use the Anyneta function.
Make sure to switch to an Anynet+ device by using the Device List.
Recording
You can make a recording of a TV Program using a Samsung recorder.
1. Select Recording.
When there are more than two recording devices
• When multiple recording devices are connected, the recording devices are listed. Select one recording device in
the Device List.
When the recording device is not displayed, select Device List and press the Red button to search for devices.
2. Press the EXIT button to exit.
You can record the source streams by selecting Recording: (device_name).
Pressing the [•] (REC) button will record whatever you are currently watching. If you are watching video from
another device, the video from the device is recorded.
Before recording, check whether the antenna jack is properly connected to the recording device. To properly
connect an antenna to a recording device, refer to the recording device’s users manual.
Listening through a Receiver
You can listen to sound through a receiver (i.e Home Theater) instead of the TV Speaker.
1. Select Receiver and set to On.
2. Press the EXIT button to exit.
If your receiver supports audio only, it may not appear in the device list.
The receiver will work when you have properly connected the optical in jack of the receiver to the DIGITAL AUDIO
OUT (OPTICAL) jack of the TV.
When the receiver (i.e Home Theater) is set to On, you can hear sound output from the TV’s Optical jack. When
the TV is displaying a DTV (air) signal, the TV will send out 5.1 channel sound to the receiver. When the source is
a digital component such as a DVD and is connected to the TV via HDMI, you will hear only 2 channel sound from
the receiver.
% NOTE
• You can only control Anyneta devices using the TV remote control, not the buttons on the TV.
• The TV remote control may not work under certain conditions. If this occurs, reselect the Anynete- device.
• The Anyneta functions do not operate with other manufacturers’ products.
28
English