Samsung 430 - Manual (Page 29)

Troubleshooting for Anynet+ O
Problem Possible Solution
An^/nptA HnPQ nntifl/nrlr « C m - -W I ‘'i/: ■■ 1 g ■ ■ ■ ■ : , . i ; i ; r i . i / k i ■ J ; . k . - .
« Only one receiver (home theater} can be connected.
« Check if the Anynet+ device power cord is properly connected.
« Check the Anynete device’s Video/Audio/HDMI cable connections.
• Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
« Check whether the TV remote control is in TV mode.
« Check whether the remote control is Anyiiete compatible.
• Anynete doesn’t work in certain situations. (Searching channels, operating Media Play (USB) or Plug & Play
(initial setup), etc.)
« When connecting or removing the HDMI cable, olease make sure to search devices again or turn your TV o1
and on again.
• Check if the Anynet+ Function of Anynet+ device is set on.
1 want to start Anynet+. • Check if the Anynet+ device is properly connected to the TV and check if the Anynet+ (HDMi-CEC) is set t' - On
in the Anynet+ Setup menu.
« Press the TOOLS button to display the Anynete menu and select a menu you want.
1 want to exit Anynet+. • Select View TV in the Anynet+ menu.
• Press the SOURCE button on the TV remote control and select a non- Anynet-f device.
• Press N/ CH /\, PRE-CH to change the TV mode. (Note that the channel button operates only when a tu
embedded Anynet-f device is not connected.)
The message "Connecting to
Anynet+ device..." appears on the
screen.
« You cannot use the remote control when you are configuring Anyiiete or switching to a view mode.
« Use the remote control after the TV is done Anynet-f configuring or switching to Anynet-f.
The Anynet+ device does not piay. • You cannot use the play function when Plug & Play (initial setup} is in progress.
The connected device is not
displayed.
« Check whether or not the device supports Anynet-f functions.
« Check whether or not the HDMI cable is properly connected.
• Check whether Anynet-f (HDMi-CEC) is set to On in the Anynet-f setup menu.
« Search Anynet-f devices again.
« You can connect an Anynet-f device using an HDMI cable only. Some HDMI cables may not support Anynet-f
functions.
« If connection is terminated because there has been a power interruption or the HDMI cable has been
disconnected, please repeat the device scan.
The TV Program cannot be
recorded.
« Check whether the antenna jack on the recording device is properly connected.
The TV sound is rot output
through the receiver.
« Connect the optical cable between TV and the receiver.
>
CL
O
(0
CL
Tf
CD
(t)
t/i
English 29