To change a stored number – Sony SPP-AQ600 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Speed dialing (continued)
Notes
To store the previous number dialed, press ( REDIAUPAUSE ; directly after step
2. Then go to step 4. If the number exceeds 16 digits or there is no previous
number dialed, five short error beeps sound and storing is canceled.
Do not allow more than 20 seconds to elapse between each step of the procedure.
Make sure that RING ON/BATT SAVE switch is set to RING ON.
Tips
If you enter a wrong number, start from the beginning.
You can't receive calls while you're storing numbers.
The TALK/BATT LOW lamp on the handset Bashes during storing the phone
number.
To store a number to be dialed via Private Branch Exchange (PBX)
Before entering a phone number in Step 3 on the previous page, do as
follows:
1
Enter the outside line access digit (e.g. 9).
2
Press ( REDIAL/PAUSE ) to enter a pause.
To change a stored number
Store a new number, as described on the previous page.
20'"" Advanced Fetures