Sony SPP-AQ600 - Manual (Page 3)

12. Unplug this product from the wall
outlet and refer servicing to qualified
service personnel under the following
conditions:
A. When the power cord or plug is
damaged or frayed.
B. If liquid has been spilled into the
product.
C. If the product has been exposed to
rain or water.
D. If the product does not operate
normally by following the
operating instructions. Adjust
only those controls that are
covered by the operating
instructions because improper
adjustment of other controls may
result Tff damage and will often
require extensive work by a
qualified technician to restore the
product to normal operation.
E. If the product has been dropped or
the cabinet has been damaged.
F. If the product exhibits a distinct
change in performance.
13. Avoid using a telephone (other than a
cordless type) during an electrical
storm. There may be a remote risk of
electric shock from lightning.
14. Do not use the telephone to report a
gas leak in the vicinity of the leak.
SAVE THESE
INSTRUaiONS
CAUTION:
TO REDUCE THE RISK OF FIRE OR INJURY TO
PERSONS BY BATTERY. READ AND FOLLOW
THESE INSTRUCTIONS.
I. Use only the I'ollowing type and size battery
pack: SONY BP-TI6.
2. Do not dispose olThe battery pack in a fire. The
cell may explode. Check with local codes for
possible special disposal instructions.
3. Do not open or mutilate the battery pack.
Released electrolyte is corrosive and may cause
damage to the eyes or skin. It may be toxic if
swallowed.
4. Exercise care in handling battery in order not to
short the battery with conducting materials such
as rings, bracelets, and key. The battery or
conductor may overheat and cause burns.
5. Charge the battery pack prov ided with or
identified for use with this product only in
accordance with the instructions and limitations
specified in the instruction manual provided for
this product.
6. Observe proper polarity orientation between the
battery pack and battery charger.
7. Do not mix old and new batteries in this
product.
8. Do not mix batteries of different sizes or from
different manufactures in this product.
INFORMATION FOR
GENERAL TELEPHONES
1. This equipment complies w ith Part 68 of the
FCC rules. On the bottom of this equipment is a
label that contains, among other information, the
FCC regislralifui number and ringer equivalence
number (REN ) for this equipment. If requested,
this information must be provided to the
telephone company.
2. The applicable registration jack (connector)
USOC-RJI 1C is used for this equipment.
3. This equipment is designed to be connected to
the telephone network or premises wiring using
a compatible modular jack w hich is Pan 68
compliant.
The FCC compliant telephone cord and modular
plug is provided w ith this equipment.
4. The REN is used to determine the quantity of
devices which may be connected to the
telephone line. Excessive RENs on the
telephone line may result in the devices not
ringing in response to an incoming call. In
most, but not all areas, the sum of the RENs.
should not exceed five (5.0). To be certain of
the number of dev ices that may be connected to
a line, as determined by the total RENs. contact
the local telephone company.