Sony STR-DA50ES - Manual (Page 11)

S-LINK CONTROL Al hookup
• If you have a S-LINK CONTROL A1-compatible
Sony CD player, tape deck, or MD deck
Use a CONTROL A1 cord (not supplied) to connect the
S-LINK CTRL A1 jack on the CD player, tape deck, or
MD deck to the S-LINK CTRL A1 jack on the receiver.
Refer to the separate manual "CONTROL-A1 Control
System" and the operating instructions supplied with
your CD player, tape deck, or MD deck for details.
Note
If you make CONTROL A1 connections from the receiver to an
MD deck that is also.cormected to a computer, do not opérate
the receiver while using the "Sony MD Editor" software. This
may cause a malfunction.
• If you have a Sony CD changer with a
COMMAND MODE selector
If your CD changer's COMMAND MODE selector can
be set to CD 1, CD 2, or CD 3, be sure to set the
command mode to "CD 1" and coimect the changer to
the CD jacks on the receiver.
If, however, you have a Sony CD changer with VIDEO
OUT jacks, set the command mode to "CD 2" and
cormect the changer to the VIDEO 2 jacks on the
receiver.
Connecting the AC power cord
Before cormecting the AC power cord of this receiver to a
wall outlet:
• Connect the speaker system to the receiver (see page
13).
• Turn the MASTER VOLUME control to the leftmost
position (0).
Connect the AC power cord(s) of your audio / video
components to a wall outlet.
If you cormect other audio/video components to the AC
OUTLET(s) on the receiver, the receiver will supply power
to the cormected component(s), allowing you to turn the
whole system on or off when you turn the receiver on/off.
Caution
Make sure that the total power consumption of the component(s)
connected to the receiver’s AC OUTLET(s) does not exceed the
wattage stated on the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons, fans, or TVs to
this outlet.
X
0
o
*■
s'
<a
c
■o
r*
y
A
n
o
3
3
n
3
cr
Setting the voltage selector (for models
suppilied with a voltage selector)
Check that the voltage selector on the rear panel of the
receiver is set to the local power supply voltage. If not,
use a screwdriver to set the selector to the correct position
before cormecting the AC power cord to a wall outlet.
11