Sony STR-DA50ES - Manual (Page 45)

No sound or only a very low-level sound is heard
from the rear speakers.
^ Make sure the sound held function is on (press
SOUND FIELD ON/OFF).
^ Select a sound field from the CINEMA or
VIRTUAL 3D genres (except MONO MOVIE and
STEREO MOVIE) (see page 28).
Adjust the speaker volume (see page 18).
^ Make sure the rear speaker size parameter is set to
either SMALL or LARGE (see page 15).
Recording cannot be done.
^ Check that the components are connected correctly.
^ Select the source component by rotating the .
FUNCTION control.
When recording from a digital component, make
sure the input mode is set to ANALOG (see page
23) before recording with a component connected
to the analog MD/DAT or TAPE terminals.
When recording from a digital component, make
sure the input mode is set to DIGITAL (see page
23) before recording with the component
connected to the DIGITAL MD/DAT OUT
terminals.
Radio stations cannot be tuned in.
^ Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
^ The signal strength of the stations is too weak
(when tur\ing in with automatic tuning). Use
direct tuning.
Make sure you set the tuning interval correctly
(when tuning in AM stations with direct tuning)
(see pages 38 and 47).
^ No stations have been preset or the preset stations
have been cleared (when tuning by scanning preset
stations). Preset the stations (see page 39).
^ Press DISPLAY so that the frequency appears in
the display.
The surround effect cannot be obtained.
Make sure the sound field function is on (press
SOUND FIELD ON/OFF).
^ Make sure that the SPEAKERS selector is set to A
or B (not A+B) if you connected two sets of front
speakers.
No picture or an unclear picture appears on the
TV screen or monitor.
^ Select the appropriate function on the receiver.
Set your TV to the appropriate input mode.
Move your TV away from the audio components.
The video image on the TV screen or monitor
does not correspond to the selected component.
^ Check the source of the video signal by pressing
MODE repeatedly to display "V:XXX". Then rotate
FUNCTION to select the appropriate video source
(if necessary).
The remote does not function.
^ Point the remote at the remote sensor B on the
receiver.
^ Remove any obstacles in the path between the
remote and the receiver.
^ Replace all batteries in the remote with new ones,
if they are weak.
^ Make sure you select the correct function on the
remote.
^ If the remote is set to operate the TV only, use the
remote to select a source or component other than
TV before operating the receiver or other
component.
Reference sections for clearing the
receiver's memory
To clear See
All memorized settings page 19
Customized sound fields page 35
>
a.
a.
S*'
o’
3
SL
3
o
3
fii
o’
3
45