Sony CCD-F33 - Manual (Page 31)

To re-record a picture in the
middle of a recorded tape
(Insert recording) CJQ
M-1
1 While pressing the small button, set the
POWER switch to CAMERA.
2 Slide the STANDBY switch up to set the unit to
recording pause mode.
3 While looking in the viewfinder, keep pressing
the "+” or side of the EDITSEARCH button
and release the button where you want to end
the insert.
The unit will be set to recording pause mode.
4 Press the COUNTER RESET button.
The counter is set to zero.
5 While looking in the viewfinder, keep pressing
the side of the EDITSEARCH button and
release the button at the point where you want
to start the insert.
6 Press the ZERO MEM button.
The insert ending point is stored in the
memory.
7 Press the START/STOP button.
Insert recording will begin. The insert recording
will stop automatically near the counter zero
point.
To cancel ZERO MEM mode
Press the ZERO MEM button so that the ZERO
MEM indicator disappears.
To change the insert ending point
Press the ZERO MEM button to turn off the
ZERO MEM indicator and repeat steps 3 through
6 above.
Notes
• When recording pause mode lasts for
approximately 5 minutes, pause mode will be
automatically released and the unit will be turned
off.
• When the inserted tape is played back, the picture
may be distorted at the end of the inserted
program.
31