Tv/vcr hookups, Getting started – Sony STR-DE905G User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Rear and center speakers
Rear
speaker
(R)
Receiver
Rear
Center
speaker
speaker
(L)
Active woofer
Receiver Active woofer
0
If your TV monitor uses separate speakers
You can connect one of them to the SURROUND OUT
CENTER terminal for use with Dolby Pro Logic
Surround Sound (see page 32).
Selecting the impedance
Set the IMPEDANCE SELECTOR for the front speakers
as indicated in the table below. Check the instruction
manual of your speakers if you're not sure of the
impedance. (This information is usually printed on a
label on the back of the speaker.)
if nominal impedance of
Set IMPEDANCE SELECTOR to
your speaker is
Between 4 and 8 ohms
4
8 ohms or higher
8
TV/VCR Hookups
Overview
This section describes how to connect video
components to the receiver. For specific locations of the
jacks, see the illustration below.
What cables will
I
need?
• Audio/video cable (not supplied) (1 for each TV or LD
plaver; 2 for each VCR)
Yellow
White
Red (R)
Yellow
White (L)
Red (R)
• Video cable (not supplied) (1 for a TV monitor)
Yellow
----------------- aimmUp= Yellow
Hookups
The arrow indicates signal flow.
Monitor
If vou are using your TV as a monitor, do not connect
anything to the TV/DBS IN jacks, unless you have a
Sony TV with TV' OUT jacks (see page 25 for details).
Receiver
TV
(^i
0
TV tuner or DBS (Digital Broadcasting Satellites) receiver
Receiver
12