Sony SLV-SE220G User Manual
Page 71
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Symptom
Remedy
O)
c
'•B
o
u
0)
u
u
0)
E
H
The PDC function does
not operate properly.
• Check that the clock and the date are set correctly.
• Check that the PDC time you set is the correct one (there
might he a mistake in the TV programme guide). If the
broadcast you wanted to record did not send the good PDC
information, the VCR will not start recording.
• If the reception is poor, the PDC signal might be altered
and the VCR might not start recording.
A tape cannot he
inserted.
• Check that a tape is not already in the tape compartment.
The remote commander
does not function.
• Make sure you are pointing the remote commander at the
remote sensor on the VCR.
• Replace all the batteries in the remote commander with
new ones if they are weak.
• Make sure the
| T V |
/
I V I D E O I
remote control switch is set
correctly.
The selected input line
connector numher does
not appear in the display
window.
• Press INPUT SELECT to display the connected line.
2
0)
£
o
The tracking meter does
not appear on the TV
screen.
• The recording condition of the tape is very poor and
tracking cannot be adjusted.
You cannot control other
TVs.
• Set your TV’s code number. The code number may change
when you replace the batteries of the remote commander.
The display window
hecomes dim.
• The display window automatically becomes dim when the
VCR is in standby or timer recording mode.
The VCR needs to he
cleaned.
• Clean the cabinet, panel and controls with a dry, soi
^
cloth,
or a soft cloth slightly moistened with a mild detergent
solution. Do not use any type of solvent, such as alcohol or
benzine.
The Line Through
function does not
operate.
• Set POWER SAVE in the USER SET menu to OFF (see
>
a
a
5'
3
w
3
o'
3
&)
5'
3
continued m
Troubleshooting 71