Set the standby switch up, At the desired point, release editsearch, Press start/stop – Sony CCD-FX310 User Manual
Page 27: To pause recording, Helpful hints for recording, If the tape reaches near the end during recording
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Re-recordlng on a Previously Recoiled Portion (EDITSEARCH)
You can reshoot a scene over the last recorded portion using EDITSEARCH. The
previously recorded portion will be erased.
1
Set the STANDBY switch up.
START/STOP
Look in the viewfinder and find the point from
where you want to begin recording by:
Keep pressing the + side of EDITSEARCH
continuously to advance the picture at a normal
playback speed, or the - side to reverse the picture.
♦ EDITSEARCH -©
At the desired point, release EDITSEARCH.
Press START/STOP.
Recording begins from the point you released EDITSEARCH.
A smooth transition between scenes can be made after the
pre-recorded portion even if STANDBY is turned down and
turned up, or even if the power is turned off and on again,
provided that the tape is not removed.
To pause recording
Press START/STOP again.
To stop recording
Set the STANDBY switch down.
Helpful Hints for Recording
if the tape reaches near the end during recording
The 0^ indicator and the red lamp in the viewfinder and the camera recording/battery
iamp on the camcorder blink slowly. When the tape reaches its end, blinking becomes
rapid and beeps sound for about five seconds (if BEEP is set to ON).
Notes on recording
• To record from the beginning of the tape, run the beginning of the tape for about 15 seconds
before recording. This will avoid missing the starling point when the tape is played back.
• When moving from indoors to outdoors, or vice versa, turn STANDBY up and point the
camcorder at a white object for about 10 seconds so that the white balance is properly
adjusted.
Note on standby mode
If you leave the camcorder in the standby mode for 5 minutes or more, the camcorder will
be automatically turned off. To resume the standby mode, turn STANDBY down and turn it
up again. To start recording, press START/STOP directly.
Note on light sources
If you are shooting a subject in bright conditions just after shooting in a dark place, the picture
may not appear in the viewfinder. In this case, point the camcorder in the other direction.
Advanced Camera Operation
27