Removing the battery pack, Battery life and remaining capacity – Sony CCD-FX310 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1 Align the flat side ot the battery pack with the white line on the camcorder.
2 Make sure that the arrow on the battery pack is close to the top of the camcorder.
3 Push down and slide the battery pack in the direction of the arrow.
Notes
• Make sure the battery is securely installed so that it does not fall off. If the battery is not
installed properly, the camcorder will not record accurately.
• You can use the AC power adaptor as a power source when recording indoors.
Removing the battery pack
Slide the ВАТТ switch in the direction of the arrow, and at the same time, slide out the
battery pack to the left.
Battery life and remaining capacity
A fully charged battery pack lasts for:
Type of battery pack
NP-55
(supplied)
NP-77H/'
NP-77HD
NF>-77
Mi^-66H
NP-55H
Battery life
60
150
120
110
75
(approx, minutes, continuous recording when used indoors)
To check the remaining battery capacity, set the POWER switch to CAMERA set the
STANDBY switch up and press TAPE/BATT CHECK.
’
The decreasing black bar indicates decreasing
battery power. After the black bar disappears the
CX3 indicator will appear and blink and a red
lamp will also blink in the viewfinder. When they
blink rapidly, replace the battery pack.
Battery life
Indicator
Notes
• The battery life indicator of the camcorder may indicate a different remaining capacity from that of
the NP-77HD battery pack.
• Charge the battery pack when the black bar of the battery life indicator decreases quickly.
Getting Started ~J