Sony ICF-C703 - Manual (Page 4)

English
WARNING
To «void eledrieal shock do not open the cabinet
Refer seivicing to qualified personnel only.
For the Customers in Canada
THIS APPARATUS COMPUES WITH THE
CLASS B UMITS FOR RADIO NOISE
EMISSIONS SET OUT IN RADIO
INTERFERENCE REGULATIONS.
For the Customers In Canada
CAUTION:--------------------------------------------------
TO PREVENT ELECTRIC SHOCK. DO NOT
USE THIS POLARIZED AC PLUG WITH AN
EXTENSION CORD. RECEPTACLE OR
OTHER OUTLET UNLESS THE BLADES CAN
BE FUUY INSERTED TO PREVENT BLADE
EXPOSURE
NOTICE FOR THE CUSTOMERS IN THE
UNITEO KINGDOM
A moulded plug complying with BS1363 is fitted
to t№s equipment lor your satoty and convenience.
Should the hise in the plug supplied need to be
replaced, a 5 AMP fuse appro^ by ASTA or
BSI to SS1362. (i.e. mailied with ^ or ^ nMifc)
must be used.
If the plug supplied with this equipment has a
detactMbI« fuse cover, be sure » attach the fuse
cover after you change the fuse. Never use the
plug without the fuse cover. If you should lose
the fuse cover, please contact your nearest
Sony servloe station.
IMPORTANT
H the plug suppRad is not suitabl« for the socket
outlets in your home, it should be cut off and an
appropriate plug fitted in aooofdanoe with the
following irratructions.
The wires in this mains lead are ooioured in
accordance with the following code:
Blue: Neutral
Brown: Live
As the colours ol the wires in the mains lead of
this apparatus may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as fORows:
The wire «tttich is cokwrad blue must be
oonnected to the terminal which is marked with
the letter N or coloured black. The wire which Is
coloured brown must be connected to the
terminal which is marked with the letter L or
ooioured red. Do not connect either wire to the
earth terminal in the plug which is m«ked by
Ihe letter E or by the sat^ earth symbol .^or
ooioured green or green and yellow.
WARNING
To prevent shock hazard, do not insert the plug
cut off from the mains lead into a socket outlel.
This plug cannot be used and should be
Before You Begin
Thank you for choosing the Sony dock rarfiol
The dock radio wN give you many hours of
reliable servloe and lislenlng pleasure.
Before operating the dock radio, please read
these instnicfions thoroughly and retain them for
future retorenoe.
These ktstnidions cover two models:
Ihe ICF-C703 and ICF-C703L
The band for each model and the area where the
model is avaiiabie are shown below.
Operating the Radio
Manual Tuning
1. Press RADIO ONfSLEEP to turn on the
radio.
The band, frequency and preset number
indications win be displayed in the
display window after TTn* and preset
number appear tor about 2 seconds.
They cha^e to the current time
indication after about 10 seconds.
2. Adjust VOLUME.
3. Press BAND to select the band.
Every push changes the band as follows.
(The last frequency selected in each
band appears.)
LW-»AM(MW)-»FM
t________________ I
FM/AM-ICP-C703only
FMMW/LW - ICF-C703L only
4. Tune in a station by pressing the or-
button of TUMNOnriME SET.
TheFMchannetstepissettoO.t MHz
(North and South American model) or
0.05 MHz (other models; The FM
frequency indication changes every
0.1 MHz.).
The AM(MW) channel step is set to 10
kHz for models for North and South
America and 9 kHz tor models for other
countries.
The LW channel step altematss between
2kHzand7kHz.
A beep sounds at the band edge.
• To turn off the ladto. piMS RADIO OFF/ALARM
• To improve rarfo reception
FM: Since the anteivia is encased in the AC
power cord, extend the cord to improve FM
AM(MW)/LW: Rotate the untt horizontafiy tor
optitnum recaption. A ferrite bar antenna is built
ktto the unit
• To check the station you are listening to, press
RADIO ONfSLOF.
The band and frequency appear tor 10 seconds.
For the Customers Supplied with an FM
Antenna Coupler
damp the AC power cord with the supplied
coupler and connect it to a wall FM antenna
terminal for optimum FM reception.
Whew available MedsI number Band
North and South
American countries ICF-C703 ^ a M
UK ICF-C703L FM/MW/LW
Other countries ICF-C703 FMTAM
K5F-C703L FMMW/LW
3. Release A RADIO or B BUZZER.
The alarm time is set The indication
becomes the current time.
4. Press ALARM MODE till the alarm you
want to set appears in the display.
Each push changes the alarm indication
as follows.
No alarm-» A RADIO B BUZZER
t-A RADIO / B BUZZER J
When you want to set both A RADIO
and B BUZZER alarm, set both A
RADIO and B BUZZER alarm time by
performing steps 2 and 3 above.
The radio or buzzer will automatically
sound at the preset time, and
automatically turn itself off after 60
minutes, unless it is turned off manually.
«To shut off the alarm manualy, press RADIO
OFF/ALARM RESET. The alarm will come on
at the preset lime the next day.
> To cancel the alarm before the alarm time, press
ALARM MODE tiil the appropriate atoms
indicalion disappears.
• To check the preset time, press A RADIO or B
BUZZER.
• The buzzer sound ievel is fixed, and independent
oftheVOLUMEdtol.
• If you set A RADIO and B BUZZER to Ihe same
desired time, only A RADIO will work.
To Doze for a F«w Mora Mtnutas
1. F^ess SNOOZeSLEEP OFF.
The radio or buzzer Will shut off but will
automatically come on again after about 8
minutes.
You can repeat this process within 1
hour.
• When the snooze alarm function is operating, ttw
atom) indication Hashes.
Setting the Sleep Timer
Enjoy toning asleap to the radto using the built-in
sleep ttmer that stmts off the radio automatfeaty at
apresattime.
1 . Press RADIO ON/SLEEP repeatedly.
The radio turns on. You can sal the sleep
timer of 90,60,30 or 15 minutes.
Each push changes the display as
follows.
Current time -* On 90
t *
IS 4- 30 4- 60
The radio will play for the time you set,
then shut off.
• To turn off the radto before ihe preset time, press
SNOOZEfSLEEPOFF.
To Use Both Sleep Timer and Alarm
Function
You can fan astosp to the radio sound and be
awakened by the radio/buzzar atom) at Ihe preset
1. Set the alarm. (See “Setting the Alarm*)
2. Set the sleep timer. (See “Setting the
Sleep TlmaO
When the alarm time arrives wh9e the sleep timer
is working, the sleep timer is canceled and the