Using alternative power sources, Warning, Precaution – Sony CCD-TR916 User Manual
Page 20: Notes on the power lamp, To remove the adaptor, Ccd-tr86/tr96 only
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using alternative power sources
WARNING
AC power cord must only be changed at qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (mains) as long as it is connected
to the wall outlet, even if the set itself has been turned off.
Notes on the POWER lamp
• The POWER lamp will remain lit for a while even if the unit is unplugged after use.
This is normal.
• If the POWER lamp does not light, set the selector to VTR (DC OUT) and disconnect
the power cord. After about one minute, reconnect the power cord.
To remove the adaptor
The adaptor is removed in the same way as the battery pack.
gntsfejiowq ra j; ?‘W
^
- CCD-TR86/TR96 only
Use the supplied battery case and six size AA (LR6) alkaline batteries (not supplied).
(
1
)
Remove the battery holder from the battery case.
(
2
)
Insert six new alkaline batteries into the battery holder, following the marking
on the holder to be sure the batteries are installed in the correct direction,
(3)
Insert the battery holder with the alkaline batteries.
(4)
Insert the battery case with the alkaline batteries to the battery mounting
surface of the camcorder in the same way as the battery pack.
20