Trouble check – Sony CCD-TR916 User Manual
Page 56
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Trouble check
If you run into any problem using the camcorder, use the following table to
troubleshoot the problem. Should the difficulty persist, disconnect the power source
and contact your Sony dealer or local authorized Sony service facility.
caiTicorder.''fi.-" i
Power
Symptom
Cause and/or Corrective Actions
The power is not on.
• The battery pack is not installed.
-> Attach the battery pack firmly by pushing the lower part
of the battery pack until it clicks twice, (p. 8)
• The battery is dead.
Use a charged battery pack. (p. 6)
• The AC power adaptor is not connected to a wall outlet.
-> Connect the AC power adaptor to a wall outlet, (p. 19)
The power goes off.
• While being operated in CAMERA mode, the camcorder
has been in the Standby mode for more than 5 minutes.
■¥ Turn STANDBY down once and turn it up again, (p. 10)
• The battery is dead.
-> Use a charged battery pack. (p. 6)
The battery pack is quickly
discharged.
• The ambient temperature is too low. (p. 48)
• The battery pack has not been charged fully.
■> Charge the battery pack again, (p. 6)
• The battery pack is completely dead, and cannot be
recharged.
Use another battery pack. (p. 19)
Operation
Symptom
Cause and/or Corrective Actions
START/STOP does not operate.
• The tape is stuck to the drum.
■> Eject the cassette, (p. 9)
• The tape has run out.
Rewind the tape or use a new one. (p. 17)
• The POWER switch is set to PLAYER.
Set it to CAMERA, (p. 10)
• The tab on the cassette is out (red).
Use a new cassette or slide the tab. (p. 9)
The cassette cannot be removed,
from the holder.
• The battery is dead.
•> Use a charged battery pack or the AC power adaptor,
(p. 6,19)
No function except for cassette
ejection works.
• Moisture condensation has occurred.
■¥ Remove the cassette and leave the camcorder for at least
1 hour. (p. 51)
The tape does not move when a tape
transport button is pressed.
• The POWER switch is set to CAMERA or OFE.
-»SetittoPLAYER. (p. 17) ■
• The tape has run out.
Rewind the tape or use a new one. (p. 17)
56