Sony MDS-JE510 - Manual (Page 16)

Recording on MDs
Synchro-Recording With a Sony
CD Player T
connecting your deck to a Sony CD player or Hi-Fi
Component System, you can easily dub CDs onto MDs
using the CD synchro buttons on the remote. If vour
deck is connected to a Sony CD player by a digital
input cable, track numbers are automatically marked
as appear on the original regardless of whether
"LevelSync ON" or "LevelSyncOFF" is selected. If
your deck is connected to a Sony CD player by audio
connecting cords through LINE (ANALOG) IN, track
numbers are automatically marked when you select
"Le\’elSync ON" (see "Marking Track Numbers While
Recording" on page 12).
As the same remote controls both the CD player and
the deck, you may haye trouble operating both units if
they are far from each other. If you do, place the CD
player close to this deck.
STANDBY
START
STOP
CD PLAYER II
1 Set the source selector on the amplifier to CD.
2 Do Steps 2 to 5 in "Recording on an MD" on page
6 to prepare the deck for recording.
3 Insert a CD into the-CD player.
4 Select the playback mode (Shuffle Play, Program
Play, etc.) on the CD player.
5 Press STANDBY.
The CD player pauses for playing and the deck
pauses for recording.
6 Press START.
The deck starts recording and the CD player starts
playback.
The track number and elap.sod recording time of
the track appear in the display.
If the CO player does not start playing
Stime CD player models may not resjxmd when you
press START on the remote of the deck. Press II on the
remote of the CD player instead.
7 Press STOP to stop synchro-recording.
To pause recording
Press STANDBY or CD PLAYER II.
To restart recording, press START or CD PLAYER II.
A new track number is marked each time you pause
recording,
y You can use the remote of the CD player during
synchro-recording
When you press ■, the CD plaver stops and the deck
pauses for recording
When you press II, the CD player pauses and the deck
pauses for recording.
To restart synchro-recording, press O'.
y' You can change CDs during synchro-recording
Do the following steps instead of Step 7 above.
1 Press ■ on the remote of the CD player.
The deck pauses for recording.
2 Change the CD.
3 Press O on the remote of the CD player.
Synchro-recording restarts.
You can also do synchro-recording with a Sony video
CD player
Using the procedure for synchro-recording with a Sony
CD player, you can do synchro-recording with a Sony
video CD player also.
To select the video CD player, press button number 2
while pressing down the POWER button before starting
the procedure.
To select the CD player again, press button number L
while pressing down the POWER button.
The deck is factory set to a CD player for synchro­
recording.
■Q' You can check the remaining recordable time on the
MD
Press DISPLAY (see page 16).
14