Press # rec, The deck becomes ready to record, Press o- or ii. recording starts – Sony MDS-JE510 User Manual
Page 7: Start playing the program source
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Basic Operations
When ”TOC flashes in the display
The deck is currently updating the
Table Of Contents (TOC).
‘ Do not move the deck or pull out
the AC power cord. Changes to an
MD made through recording are
saved only when you update the
TOC by ejecting the MD or
changing the deck to standby by
pressing POWER.
Press # REC.
The deck becomes ready to record.
When recording the analog input signal, adjust the recording
level with REC LEVEL.
The fourth dot is satisfactory for most purposes. For details,
refer to "Adjusting the Recording Level" on page 11.
8
Press O- or II.
Recording starts.
Start playing the program source.
Do not disconnect the deck from the power source immediately after
recording
If you do, recorded material may not be saved to the MD. To save the material,
after recording, press
&
EJECT to take out the MD or change the deck to
standby by pressing POWER. 'TOC" will flash in the display at this time.
After 'TOC" stops flashing and goes out, you can pull out the AC power
cord.
To
Press
Stop recording
■
Pause recording*
II.
Press the button again or press O to
resume recording.
Take out the MD
M EJECT after stopping recording
* Whenever you pause recording, the track number increases by one. For example, if
you paused recording while recording on track 4, the track number increases by
' one anci recording continues on the new track when restarted.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction of
arrow, opening the slot. To allow recording, close the slot.
Note
If you switch REC MODE during recording or recording pause, recording stops.