Labeling tracks and mds with the remote |t, If you entered the wrong character, To cancel labeling – Sony MDS-JE510 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Editing Recorded MDs
Labeling tracks and MDs with the remote |T!
NAME
ij
—
O
o o o o o
o o o o o
0 0 0 0 0
o o o o o
o o o o o
ooooo
Alphabet/number
buttons
4
Repeat Steps 2 and 3 until you have entered the
entire title.
If you entered the wrong character
Press or ►► until the character tt' I
h
* corrected
starts flashing.
Pritss CLEAR to erase the incorrect character, then enter
the correct one.
5
Press NAME again.
The entered title appears on the left side of the
display window after the label has been recorded.
To cancel labeling
Press ■.
1
Press NAME repeatedly until a flashing cursor
appears in the display, then do the following:
To label
Make sure that the deck is
A track
Playing, pausing, recording the track
to be labeled, or stopped after
IcKating the track to be labeled
AnMD
Stopped with no track number
ap|i>earing in the display
Select the character type as follows:
To select
Press
Uppercase letters
CHAR repeatedly until "Selected
ABC" appears in the display
Lowercase letters
CHAR repeatedly until "Selected
abc" appears in the display
Numbers
NUM repeatedly until "Selected
123" appears in the display
3
Enter one character at a time.
After you enter a character, the cursor shifts
rightward and waits for the input of the next
character.
28