Sony MDS-JE520 - Manual (Page 24)

Playing MDs
b) When using the remote
Press the number buttons to enter the tracks
vou want to program in the order you want.
To program a track with a number over 25, use
the >25 button (see page 20).
li^ou enter the wrong track number
Press or ►► until the wrong track number
flashes, then enter the correct track number
with the number buttons.
It "0” flashes, press MM.
4 Repeat Step 3 to enter other tracks.
The entered track is added to the location where
the "0" flashes.
Each time you enter a track, the total program time
is added up and appears in the display.
5 After finishing programming, press YES.
"Complete!!" appears and programming is
completed.
6 Press PLAY MODE repeatedly (or PROGRAM
once) until "PROGRAM" appears in the display.
7 Press O to start Program Play.
To cancel Program Play
Press PLAY MODE repeatedly (or CONTINUE once)
when the deck is stopped until "PROGRAM"
disappears.
'Q' The program remains even after Program Play ends
When you press you can play the same program
again.
Notes
• The display shows -m - -s" instead of the total playing
time when the total playing time of the program exceeds
199 minutes.
• "ProgramFull" appears when you program over 25 tracks.
Erase the unnecessary tracks to enter other tracks.
Checking the track order
while the deck is stopped and "PROGRAM" is on,
press LEVEL/ DISPLAY/CHAR (or DISPLAY) several
times.
The track numbers appear in the order they were
programmed as follow:
'73^5^8^ 1 ^21"
To check the rest of the track order
Turn AMS.
You can scroll the display to check all the track
numbers you programmed.
Changing the track order
You can change the order of the tracks in your program
before you start playing.
To Do the following procedure
after Steps 1 and 2 in
"Creating Your Own
Program":
Erase a track Press M^ or ►► until the track
number you want to erase
flashes, then press CLEAR,
the whole
program Keep pressing CLEAR until all
programmed track numbers
disappear.
Add a
track to the
beginning of
the program 1 Press M^ until "0" flashes at
the left of the first track.
2 Do Steps 3 to 5 on pages 23
and 24.
in the middle
of the program 1 Press MM or ►► until the
track which precedes the track
to be added flashes.
2 Press AMS so that "0" flashes,
then do Steps 3 to 5 on pages
23 and 24.
to the end of
the program 1 Press MM until "0" flashes at
the right of the last track.
2 Do Steps 3 to 5 on pages 23
and 24.
Change a
program track in the 1 Press MM or ►► until the
track number you want to
change flashes.
2 Do Steps 3 to 5 on pages 23
and 24.
24 "'