Sony MDS-JE520 - Manual (Page 34)

Editing Recorded MDs
6 Press LEVEL/DISPLAY/CHAR to select the
character type as follows:
To select Press LEVEL/DISPLAY/CHAR
repeatedly until
Uppercase letters "A" appears in the display
Lo\^case letters “a" appears in the display
Numbers "0" appears in the display
4 Tr Ij ri'i IJ U S *
Turn AMS to select the character.
The selected character flashes.
Letters, numbers, and symbols appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
4 Tr 0 m U 7 s i s
You can press LEVEL/DISPLAY / CHAR to change
the character type at any time during Step 7 (see
Step 6).
8 Press AMS to enter the selected character.
The cursor shifts rightward and waits for the input
of the next character.
9 Repeat Steps 7 and 8 until vou have entered the
entire title.
If you entered the wrong character
Press or ►► until the character to be corrected
starts flashing, and repeat Steps 7 and 8 to enter
the correct character.
To erase a character
Press or ►► until the character to be erased
starts flashing, then press CLEAR.
To enter a space
Press AMS while the cursor is flashing.
10 Press YES.
This completes the labeling procedure and the title
appears in the display.
To cancel labeling
Press MENU / NO or ■.
Note
You cannot label a track or an MD while you are recording
over an existing track.
4Tr
/ I \ ► il?
0 n-i 0 7 s 1
zzz J:
34"'