Sony GDM-W900 - Manual (Page 18)

Input Signal
Warning Function
Use of the Tilt-
Swivel
If there is something wrong with the input signal, one of the
following messages appears when you turn the monitor off
and on, or when you operate the INPUT switch.
The message disappears after about 30 seconds.
[T] Shows the INPUT switch setting.
[2] Shows the input signai condition.
"FH: - kHz" indicates no horizontal sync signed.
"FV: - Hz" indicates no vertical sync signal.
"OUT OF SCAN RANGE" indicates that the input signal
is not supported by the monitor's specifications.
"NO CONNECTION" indicates that the supplied video
signal cable is disconnected from the HD15 cormector
when the INPUT switch is set to "HD15."
With the tilt-swivel, this unit can be adjusted to be viewed
at the desired angle within 310° horizontally and 20°
vertically.
To turn the unit vertically and horizontally, hold it at its
bottom with both hands as illustrated below.
Specifications
Picture tube 0.25 - 0.28 mm aperture grille pitch
24 inches measured diagonally
90-degree deflection
Approx. 482 X 304 mm (w/h)
(19 X12 inches)
22.5" viewing image
Horizontal: Max. 1920 dots
Vertical: Max. 1200 lines
Approx. 473
X
296 mm (w/h)
(18 ®/s X11 ^/4 inches)
Horizontal: 30 to 96 kHz
Verticcd: 50 to 160 Hz
HD15 (1), 5 BNC (1)
R/G/B: 75 il, 0.714 Vp-p, positive
HD/VD or Comjx)site sync
Sync-on-green: 0.286 Vp-p,
negative
AC input voltage/current
100 to 120 V, 50/60 Hz, 2.2 A
200 to 240 V, 50 - 60 Hz, 1.4 A
Max. 200 W
580
X
500
X
548 mm (w/h/d)
(22 ^/8 X 19 ^/4 X 21 ®/8 inches)
Approx. 41 kg (90 lb 6 oz)
Viewable image size
Resolution
Stcmdard image area
Deflection frequency
Input
Power consumption
Dimensions
Mass
Design and specifications are subject to change without
notice.
1 8