Sony GDM-W900 - Manual (Page 5)

Preset Modes
BS > 1 ‘ i j I 0 51
The monitor has nine factory preset modes for true "Plug &
Play" capability.
Table of preset modes
No. Resolution
(dotsxiines)
Horizontal Vertical Graphic mode
Frequency Frequency
1 640 x 480 31.5 kHz 60 Hz VGA Graphic
2 720 x 400 31.5 kHz 70 Hz VGA Text
3 1280 X1024 80.0 kHz 75 Hz VESA»
4''1600x1200 93.8 kHz 75 Hz VESA
5 1920x1080 67.5 kHz 60 Hz Sony
6 1920 X1080 84.4 kHz 72 Hz Sony
7 1600x1024 81.3 kHz 76 Hz Sony
8 1920 X1200 95.0 kHz 76 Hz Sony
9 1920 X1035 33.8 kHz 60 Hz HDTV
1) VESA is a trademark of Video Electronics Standard Associatiorr.
a 'if 0 i 9 f
When using a video mcxle that is not one of the preset
modes, some fine tuning may be required to optimize the
display to your preference. Simply adjust the monitor
according to the adjustments instructions on pages 9 to 15.
The adjustments will be stored automatically and recalled
whenever that mode is used.
A total of 16 user-defined modes can be stored in memory.
If a 17th mode is entered, it will replace the first.
For less common modes, and mcxies that may evolve in the
future, the Digital Multiscan Technology of this monitor will
perform all of the complex adjustments necessary to ensure
a high quality picture for any tinung in its frequency range.
However, due to the wide variety of video boards on the
market, it may be necessary for tire user to fine tune the
vertical/horizontal size and centering.
Recommended horizontal timing conditions
Horizontal sync width should be more than 0.8 psec.
Horizontal blanking width should be more than 2.7 psec.
Note for Windows* users
Check yoiu: video board manual or the utility program
which comes with your graphic board and select the highest
available refresh rate to maximize monitor performance.
2) Windows is a registered trademark of Microsoft Corporation in
the United States and other countries.
Selecting the Input Signal
This monitor has two signal input connectors and can
connect two computers. When the power of both computers
is on, select the signal you want to input as follows.
1 Turn on power of the monitor and the computer,
2 Select the input signal.
HD15 AUTO BNC
INPUT
To input the signal from the computer connected to
the 5 BNC's connector
Set the INPUT switch to BNC.
3 If necessary, adjust the user controls according to
your preference on pages 9 to 15.
When you set the INPUT switch to "AUTO"and
connect computers to both connectors
If you turn on or restart the computer you want to input a signal
from, or the computer is in power saving mode, the monitor may
automatically select another computer's signal. This is because no
signal is input to the monitor at that moment. If this happens,
select the signal using the INPUT switch.
For the customers using the Windows95
Even if you select SONY for the maker on the device select screen,
the model name (GDM-W900) may not appear. In this case, select
the DDC standard monitor.
To input the signal from the computer connected to
the HD15 connector
Set the INPUT switch to HD15.
If only one computer is connected or turned on
Set the INPUT switch to AUTO (center position). The
input signal is automatically selected.