HP 2566C - Manual (Page 67)

Some configuration parameters can only be modified by a
^ Hewlett-Packard Service Representative. In these cases, the
( fine adj , )
keys have no effect.
4. Press
[ENTER
1
This sets the new parameter and the printer returns to the STATUS
mode.
Table 5-1. Configuration Function Numbers
Function # Description
Parameter
Range Comments
1 Select Primary Character Set 0-95 See pg. 5-3
2 Select Secondary Character Set 0-95 See pg. 5-3
7 Select Page Length
Representation
0,1 See pg, 5-4
20-29* Configure Interface 00-FF See pg. 5-5
50 Disconnect Modem 0.1 See pg. 5-4
51 Difficult Forms Mode 0,1 See pg. 5-4
52 Horizontal Graphics Density 60,70 See pg. 5-4
60 Perforation Skip 0,1 See pg. 5-5
61 Display Functions 0,1 See pg. 5-5
80 Enable/Disable Label Card 0,1 See HP Label
Card Manual
26062-90902
81 Printronix P-Series Line Feed
Emulation
0,1 See HP Label
Card Manual
85-89 Configure Label Card 00,FF See HP Label
Card Manual
• Functions 20-29 are dependent on which interface is installed (see your
Interface manual)
5-2 PRINTER CONFIGURATION