When in the configuration mode, pressing the, Key stores the selected parameter. when the, Key to select the value, then press – HP 2566C User Manual
Page 82: When the, Key is, The printer
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ENTER KEY:
(
enter
)
When in the CONFIGURATION mode, pressing the
(
enter
)
key stores
the selected parameter. When the
(
enter
)
key is pressed in the TEST
mode, the printer starts running a test. In the SET TOP OF FORM
mode, pressing the
(
enter
)
key sets the new Top of Form (then the
printer returns to the STATUS mode).
PAGE LENGTH
ADJUST KEY:
(
page
l
.
adj
.)
This key displays the physical forms length in either physical text
lines-per page, or in | inch increments. Although the printer is in the
CONFIGURATION mode, usually one decimal point lights up (for
example, 11.5 for 11 ^ inches). You can adjust the forms length setting
by pressing either
[
fine
adj
.)
key to select the value, then press
[
enter
)
to store it and return to the STATUS mode. Refer to page 3-25 for more
information on acyusting forms length. If you use programmable VFC
to set the page length, the page length setting on the panel must
match the VFC setting, otherwise the printer will not properly
sense paper-out.
ON LINE KEY:
(
on
line
)
This key gives control of the printer to the operator (“off-line”) or to
the computer ^stem (“on-line”). A yellow dot lights up in the display
window when the printer is “on-line.” The keys on the Operator
Control Panel only work when the printer is “off-line.” Press
(
on
line
)
to exit from the CONFIGURATION, TEST, SET TOP OF FORM, LPI
Adjust and Page Length Adjust modes. The printer saves the previous
configuration and Top of Form setting, and turns control over to the
host. Pressing
[
on
line
)
when running a self-test aborts the test and
turns control over to the host. The printer will not go “on-line” if there
is an error condition present.
LINE FEED KEY:
(
line
feed
)
When the
[
line
feed
)
key is
pressed,
the printer
advances
to the next
print line. If you hold down the key, the printer pauses momentarily
then advances paper at an increased rate. As long as you hold down
the key, it will advance paper. The
(
line
feed
) key functions only when
the printer is “off-line” and will not work in the CONFIGURATION or
TEST mode.
FORM FEED KEY:
(
form
feed
1
This key advances the paper to the next Top of Form position. If pressed
once, the printer moves one form feed. If you hold down the key, the
printer performs continuous form feeds. This key functions only when
the printer is “off-line” and will not work in the CONFIGURATION or
TEST mode.
USING THE PRINTER 6-7