Craftsman 139.53664SRT2 - Manual (Page 20)

Installation Step 9
Electrica! Requirements
To reduce the risk of electric shock, your garage
door opener has a grounding type plug with a third
grounding pin. This plug will on/yfit into a grounding
type outlet.
If the plug doesn't fit into the outlet you have,
contact a qualified electrician to install the proper
outlet.
To prevent electrocution or fire, installation
and wiring must be in compliance with local
electrical and building codes.
Do NOT use an extension cord, 2-wire adapter,
or change the plug in any way to make it fit
your outlet.
To avoid installation difficulties,
do not run the opener at this time.
WnoniG
If permanent wiring is required by your local code, refer to the following procedure:
To prevent eiectrocution, remove power from
the garage door opener anditom the circuit
you plan to use for the permanent connection.
To make a permanent connection through the
7/8" diameter hole in the top of the opener
(according to local code):
• Remove the opener cover screws and set the
cover aside.
• Remove the attached 3-prong cord.
• Connect the black (line) wire to the screw on the
brass terminal: the white (neutral) wire to the
screw on the silver terminal; and the ground wire
to the green ground screw.
The opener must be
grounded.
• Reinstall the cover.
Permanent
Wiring
Connections
To avoid instaiiation difficuities,
do not run the opener at this time.
Black
Wire
20