Craftsman 139.53664SRT2 - Manual (Page 33)

Receiver and Remote Control Programming
Your garage door opener receiver and remote control
have been pre-set at the factory. The door will open
when you press the LARGE remote control push
button. The code between the remote control and the
receiver changes with each use, randomly accessing
over too billion new codes.
The 3-function remote control can also activate
additional SECURITY+ garage door openers and/or
light controls.
Your SECURITY* opener will operate with:
several SECURITY* remote controls (with blue
push buttons) utilizing up to 8 functions,
one SECURITY* Keyless Entry System (Model
139.53684).
Follow the instructions below to program your opener
to match any additional remotes you may purchase.
See Accessories on page 38.
To Add A Remote Control
If you have a Premium Control Console:
1. Witii the door dosed, press and hold a remote
control push button. See Figure 1.
2. Press and hold the Light button on the door
control.
3. Press and hold the door control push button.
4. After the opener light flashes, release all buttons.
Test by pressing the remote push button.
If you do not have a Premium Control Console:
1. Press and holdVr\e selected remote control push
button. See Figure 1.
2. Then press and release the SRT (learn) button on
the back panel of the opener, Figure 2. The
indicator light on the panel will begin to blink and
the opener light will flash once.
3. Release the remote push button.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the SRT button on the opener panel
until the indicator light turns off (about 6 seconds). All
remote control codes are now erased. Then follow
the steps above to re-program each remote control.
To comply with FCC rules, adjustment or modifications of this receiver
and/or transmitter are prohibited, except for changing the code setting or
repiacing the battery. THERE ARE NO OTHER USER SERFICEABLE
PARTS.
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could dose and cause serious
injury or death. Do not allow children to operate
the door push button(s) or remote control(s).
A moving garage door couid injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
Figure 1
Seiect a remote control push
button to operate opener
SECURITY+
3-Function
Remote Control
Figure 2
SECURITY*
Garage Door Opener
tfs I Ifs I
o o
SRT (learn) Indicator
Button Lipllt
RIGHT
PANEL
To Control the Opener Light (Premium Consoles)
With SECURITY* remote controls, a push button can
be programmed to operate the opener light without
opening the door.
1. With the door dosed, press and hold the remote
button that you want to control the light.
2. Press and hold the Light button on the door
control.
3. Press and hold the Lock button on the door control.
4. After the opener light flashes, release all buttons.
Test by pressing the remote push button. The opener
light should turn on or off but the door should not move.
33