Protect pump, Hotice, Other storage tips – Craftsman 580.752300 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Change Engine Oil
While engine is still warm, drain oil from crankcase. Refill
with recommended grade. See
Changing Engine Oil.
Oil Cylinder Bore
» Remove spark plug. Squirt about 1 tablespoon of clean
engine oil into the cylinder. Cover spark plug hole with
rag. Pull recoil handle slowly to distribute oil. Avoid spray
from spark plug hole.
* Install spark plug. DO l\IOT connect spark plug wire.
Protect Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver, Model 6039, to treat
pump. This prevents freeze damage and lubricates pistons
and seals.
HOTICE
You must protect your unit from freezing temperatures.
• Failure to do so will permanently damage your pump and
render your unit inoperable.
• Freeze damage is not covered under warranty.
NOTE:
PumpSaver is available as an optional accessory, it is
not included with the pressure washer. Contact your local
Sears service center to purchase PumpSaver.
To use PumpSaver, make sure the pressure washer is turned
off and disconnected from supply water. Read and follow all
instructions and warnings given on the PumpSaver container.
Other Storage Tips
1. DO NOT store fuel from one season to another unless it
has been treated as described in
Protect Fuel System.
2.
Replace fuel container if it starts to rust. Rust and/or dirt
in fuel can cause problems if it’s used with this unit.
3.
Cover unit with a suitable protective cover that does not
retain moisture.
A WARNING
Ü
storage covers can be flammable.
DO NOT place a storage cover over a hot pressure washer.
Let equipment cool for a sufficient time before placing the
cover on the equipment.
4.
Store unit in a clean and dry area.
22