Craftsman 580.752300 User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Problem

Cause

Correction

Pump has following problems: failure
to produce pressure, erratic pressure,

chattering, loss of pressure, low water
volume.

1. Low pressure spray tip installed.

2.

Water inlet is blocked.

3.

inadequate water supply.

4.

Inlet hose is kinked or leaking.

5.

Clogged inlet hose strainer.

6.

Water supply is over 100°F.

7.

High pressure hose is blocked or
leaks.

8. Gun leaks.

9.

Spray tip is obstructed.

10.

Pump is faulty.

1.

Replace spray tip with high pressure

spray tip.

2.

Clear inlet.

3.

Provide adequate water flow.

4.

Straighten inlet hose, patch leak.

5.

Check and clean inlet hose strainer.

6.

Provide cooler water supply.

7.

Clear blocks in outlet hose.

8.

Replace gun.

9.

Clean spray tip.

10. Contact Sears service facility.

Detergent fails to mix with spray.

1. Detergent siphoning tube is not

submerged.

2.

Detergent siphoning tube/filter is

clogged or cracked.

3.

High pressure spray tip installed.

1.

Insert detergent siphoning tube into
detergent.

2.

Clean or replace fiiter/detergent

siphoning tube.

3.

Replace spray tip with low pressure

spray tip.

Engine runs

good

at no-load but "bogs"

when load is added.

Engine speed is too slow.

Move throttle control to EAST position. If

engine still "bogs down”, contact Sears
service facility.

Engine will not start; or starts and runs
rough.

1.

Low oil level.

2.

Dirty air cleaner.

3.

Out of fuel.

4.

Stale fuel.

5.

Spark plug wire not connected to

spark plug.

6.

Bad spark plug.

7.

Water in fuel.

8.

Overchoking.

9.

Excessively rich fuel mixture.

10.

Intake valve stuck open or closed.

11.

Engine has lost compression.

1.

Fill crankcase to proper level.

2.

Clean or replace air cleaner.

3.

Fill fuel tank.

4.

Drain fuel tank; fill with fresh fuel.

5.

Connect wire to spark plug.

6.

Replace spark plug.

7.

Drain fuel tank; fill with fresh fuel.

8.

Open choke fully and crank engine.

9.

Contact Sears service facility.

10.

Contact Sears service facility.

11.

Contact Sears service facility.

Engine shuts down during operation.

Out of fuel.

Fill fuel tank.

Engine lacks power.

Dirty air filter.

Replace air filter.

Engine "hunts" or falters.

Choke is opened too soon.

Move choke to halfway position until

engine runs smoothly.

23

Advertising